Info

Godox LiteFlow reflector 100cm Kit K1A
The Godox LiteFlow reflector 100cm Kit K1A consists of two double-sided mirrored reflector panels of 100 by 100 cm, each in its own yoke. One panel carries versions D1 and D3, the other D2 and D4, so you have all four light characters to hand by turning the panel over. This size lifts a whole set without putting a second fixture there.

Highlights

• Two double-sided panels of 100 x 100 cm
• D1 and D3 on one panel, D2 and D4 on the other
• Only 3 percent light loss on the bounce
• A yoke per panel, so you lock the angle
• Weighs 18.12 kg per panel

The four versions
D1 gives hard light and extends the light path so it falls off naturally. D2 spreads direct light and redirects it. D3 gives soft, natural shadows and is the one for fill. D4 pulls the beam into a strip. Because the panels are double-sided, you change character by turning the panel around.

How it works
A panel bounces the light back with roughly 3 percent loss, so you keep almost all the output. Aim a parallel source at it and the angle decides where the light lands. At this size that is enough to light a set or a whole wall.

Setting up
Each panel sits in a yoke that sets and locks the angle. At 18.12 kilos per panel it wants a solid stand underneath. A version with the FC04 flight case is available if you move the set often.

Characteristics

• Type: Reflector panel set
• Number of panels: 2, double-sided
• Versions: D1 and D3 on one panel, D2 and D4 on the other
• Dimensions per panel: 100 x 100 cm
• Light loss: approximately 3 percent
• Frame: a yoke per panel
• Weight per panel: 18.12 kg
• Warranty: 2 years

In the box

• 1 x Godox double-sided LiteFlow 100, D1 and D3
• 1 x Godox double-sided LiteFlow 100, D2 and D4
• 2 x yoke